2014 Hilux · Service Manual CRUISE CONTROL SYSTEM

TC and CG Terminal Circuit

Circuit diagnosis · Vehicles built from Jun 2011

DESCRIPTION

Connecting terminals TC and CG of the DLC3 enables DTCs to be read through blinking patterns of the combination meter's cruise control indicator light.

HINT:
When a warning light of the combination meter blinks continuously, terminal TC of the DLC3 or an ECM may have a ground short.


WIRING DIAGRAM

E110507E58

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (DLC3 - ECM AND BODY GROUND)
E216584E01
  1. Disconnect the D1 DLC3 connector.

  1. Disconnect the E14*1, E30*2 or E5*3 ECM connector.

    1. *1: for 1GR-FE
    2. *2: for 1KD-FTV (for DPF)
    3. *3: for 1KD-FTV (except DPF)

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for 1GR-FE:
    Tester Connection
    Specified Condition
    D1-13 (TC) - E14-23 (TC)
    Below 1 Ω
    D1-13 (TC) - Body ground
    10 kΩ or higher
    D1-4 (CG) - Body ground
    Below 1 Ω
    for 1KD-FTV (for DPF):
    Tester Connection
    Specified Condition
    D1-13 (TC) - E30-23 (TC)
    Below 1 Ω
    D1-13 (TC) - Body ground
    10 kΩ or higher
    D1-4 (CG) - Body ground
    Below 1 Ω
    for 1KD-FTV (except DPF):
    Tester Connection
    Specified Condition
    D1-13 (TC) - E5-11 (TC)
    Below 1 Ω
    D1-13 (TC) - Body ground
    10 kΩ or higher
    D1-4 (CG) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM


← Cruise Main Indicator Light Circuit (from Jun 2011)COMPONENTS (from Jun 2011) →