2014 Hilux · Service Manual CRUISE CONTROL SYSTEM

Cruise Main Indicator Light Circuit

Circuit diagnosis · Vehicles built from Jun 2011

DESCRIPTION

When the cruise control main switch is turned ON, the cruise control indicator light illuminates in green.
For 1KD-FTV (for DPF) vehicles, the cruise control indicator light illuminates in yellow when a malfunction occurs.

WIRING DIAGRAM

E216590E01

INSPECTION PROCEDURE


1. INSPECT FUSE (MET)
  1. Remove the MET fuse from the driver side junction block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    MET fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


2. CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM, BATTERY AND BODY GROUND)
E216583E01
  1. Disconnect the E13*1, E30*2 or E6*3 ECM connector.

    1. *1: for 1GR-FE
    2. *2: for 1KD-FTV (for DPF)
    3. *3: for 1KD-FTV (except DPF)

  1. Disconnect the C25 and C26 meter connector.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    C25-21 - Body ground
    Ignition switch ON
    11 to 14 V
    C25-21 - Body ground
    Ignition switch off
    Below 1 V


    Standard Resistance:
    for 1GR-FE:
    Tester Connection
    Switch Condition
    Specified Condition
    C26-8 - E13-18 (PI)
    Always
    Below 1 Ω
    C26-8 - Body ground
    Always
    10 kΩ or higher
    C25-22 - Body ground
    Always
    Below 1 Ω
    for 1KD-FTV (for DPF):
    Tester Connection
    Switch Condition
    Specified Condition
    C26-8 - E30-34 (PI)
    Always
    Below 1 Ω
    C26-27 - E30-7 (CCW)
    Always
    Below 1 Ω
    C26-8 - Body ground
    Always
    10 kΩ or higher
    C26-27 - Body ground
    Always
    10 kΩ or higher
    C25-22 - Body ground
    Always
    Below 1 Ω
    for 1KD-FTV (except DPF):
    Tester Connection
    Switch Condition
    Specified Condition
    C26-8 - E6-3 (PI)
    Always
    Below 1 Ω
    C26-8 - Body ground
    Always
    10 kΩ or higher
    C25-22 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Cruise Control Switch Circuit (from Jun 2011)TC and CG Terminal Circuit (from Jun 2011) →