12 Crankshaft Position Sensor Circuit Malfunction
Diagnostic trouble codes · Vehicles built from Jun 2011
DESCRIPTION
The crankshaft position sensor in the Engine Control System contains a signal plate and a pickup coil for TDC signal. The TDC signal plate has 1 tooth on its outer circumference. The TDC signal sensor generates 1 signal for every engine revolution. The ECM detects the top dead center position based on the TDC signals.| DTC No. |
DTC Detection Condition |
Trouble Area |
| 12 |
No TDC signal to ECM at 400 rpm or more |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT CRANKSHAFT POSITION SENSOR |
Check the crankshaft position sensor installation.

Disconnect the crankshaft position sensor connector.
Measure the resistance of the crankshaft position sensor.
- Standard resistance:
Tester Connection
Condition
Specified Condition
1 - 2
Cold
19 to 32 Ω
1 - 2
Hot
24 to 37 Ω
- NOTICE:
- In the chart above, the terms "cold" and "hot" refer to the temperature of the sensor. "Cold" means approximately -10 to 50°C (14 to 122°F). "Hot" means approximately 50 to 100°C (122 to 212°F).
|
|
||||
| OK | |
| 2. CHECK ECM (TDC, NE SIGNAL) |
While cranking or idling, measure the waveform according to the value(s) in the table below.

- OK:
Tester Connection
Specified Condition
E23-17 (TDC+) - E23-16 (TDC-)
Correct waveform is as shown
E23-19 (NE+) - E23-18 (NE-)
Correct waveform is as shown
|
|
||||
| NG | |
| 3. CHECK WIRE HARNESS (ECM - CRANKSHAFT POSITION SENSOR) |
Disconnect the C4 crankshaft position sensor connector.

Disconnect the E23 ECM connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
C4-1 (+) - E23-17 (TDC+)
Below 1 Ω
C4-2 (-) - E23-16 (TDC-)
Below 1 Ω
E23-17 (TDC+) - E23-16 (TDC-)
10 kΩ or higher
E23-17 (TDC+) - Body ground
10 kΩ or higher
E23-16 (TDC-) - Body ground
10 kΩ or higher
|
|
||||
| OK | ||
| ||
