2014 Hilux · Service Manual ENGINE

13 (2) Engine Speed Sensor Circuit Malfunction

Diagnostic trouble codes · Vehicles built from Jun 2011

DESCRIPTION

The engine speed sensor in the Engine Control System contains a signal plate and a pickup coil for NE signal. The NE signal plate has 56 teeth and is mounted in the injection pump. The NE signal sensor generates 56 signals for every 2 engine revolutions. The ECM detects the engine speed and cam lift position of the injection pump. The ECM uses TDC signals and NE signals for injection timing control. NE signals are also used for injection volume control.
DTC No.
DTC Detection Condition
Trouble Area
13 (2)
No NE signal to ECM for 0.5 sec. or more at 680 rpm or more
  1. Open or short in engine speed sensor circuit
  2. Engine speed sensor
  3. ECM
No NE signal to ECM for 2.0 sec. or more during cranking

WIRING DIAGRAM

A261023E01

INSPECTION PROCEDURE


1. INSPECT ENGINE SPEED SENSOR

  1. A105092E02
    Check the engine speed sensor installation.

  1. Disconnect the engine speed sensor connector.

  1. Measure the resistance of the engine speed sensor.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (NE-) - 2 (NE+)
    20°C (68°F)
    205 to 255 Ω

    HINT:
    The engine speed sensor is integrated with the injection pump assembly. If the engine speed sensor needs to be replaced, the entire injection pump assembly must be replaced.



NG
CHECK AND REPLACE INJECTION PUMP ASSEMBLY
OK


2. CHECK ECM (TDC, NE SIGNAL)

  1. A106823E05
    While cranking or idling, measure the waveform according to the value(s) in the table below.

    OK:
    Tester Connection
    Specified Condition
    E23-19 (NE+) - E23-18 (NE-)
    Correct waveform is as shown
    E23-17 (TDC+) - E23-16 (TDC-)
    Correct waveform is as shown



OK
REPLACE ECM
NG


3. CHECK WIRE HARNESS (ECM - ENGINE SPEED SENSOR)

  1. A106825E03
    Disconnect the engine speed sensor connector.

  1. Disconnect the E23 ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E19-2 (NE+) - E23-19 (NE+)
    Below 1 Ω
    E19-1 (NE-) - E23-18 (NE-)
    Below 1 Ω
    E23-19 (NE+) - E23-18 (NE-)
    10 kΩ or higher
    E23-19 (NE+) - Body ground
    10 kΩ or higher
    E23-18 (NE-) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

CHECK FOR INTERMITTENT PROBLEMS


← 12 Crankshaft Position Sensor Circuit Malfunction (from Jun 2011)14 (4) Timing Control System Malfunction (from Jun 2011) →