REMOVAL
Removal / installation · Vehicles built from Jun 2011
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE ACCELERATOR PEDAL ROD |
Disconnect the accelerator pedal position sensor connector.

Remove the 2 bolts and accelerator pedal rod.
- NOTICE:
- Do not drop or strike the accelerator pedal rod.
- Do not disassemble the accelerator pedal rod.
- This accelerator pedal does not require lubrication.
Do not apply oil or other lubrication to the accelerator pedal rod.
If applied, the accelerator pedal rod must be replaced.
- Do not drop or strike the accelerator pedal rod.
