HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Aug 2012 – Jul 2013
Versions by build date: Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014
- HINT:
- The TCM is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.
- *: Use the intelligent tester.
- The TCM is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
Refer to How To Troubleshoot ECU Controlled Systems in the Introduction section (Click here).
| |||||
| 3.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
| |||||
| 4.CONNECT INTELLIGENT TESTER TO DLC3* |
| |||||
| 5.CHECK AND CLEAR DTCS AND FREEZE FRAME DATA* |
Refer to DTC Check / Clear (Click here).
| |||||
| 6.VISUAL INSPECTION |
| |||||
| 7.SETTING CHECK MODE DIAGNOSIS* |
Refer to Check Mode Procedure (Click here).
| |||||
| 8.PROBLEM SYMPTOM CONFIRMATION |
Refer to Road Test (Click here).
Result Result
Proceed to
Symptom does not occur
A
Symptom occurs
B
|
|||||
| |||||
| 9.SYMPTOM SIMULATION |
Refer to Electronic Circuit Inspection Procedure (Click here).
| |||||
| 10.DTC CHECK* |
Refer to DTC Check / Clear (Click here).
Result Result
Proceed to
DTC is not output
A
DTC is output
B
|
|||||
| |||||
| 11.BASIC INSPECTION |
Refer to Park/Neutral Position Switch (Click here).
Refer to Shift Lever Assembly (Click here).
|
|||||
| |||||
| 12.MECHANICAL SYSTEM TESTS |
Refer to Mechanical System Tests (Click here).
|
|||||
| |||||
| 13.HYDRAULIC TEST |
Refer to Hydraulic Test (Click here).
|
|||||
| |||||
| 14.MANUAL SHIFTING TEST |
Refer to Manual Shifting Test (Click here).
|
|||||
| |||||
| 15.PROBLEM SYMPTOMS TABLE CHAPTER 1 |
Refer to Problem Symptoms Table (Click here).
|
|||||
| |||||
| 16.PROBLEM SYMPTOMS TABLE CHAPTER 2 |
Refer to Problem Symptoms Table (Click here).
| |||||
| 17.PART INSPECTION |
|
|||||
| |||||
| 18.DTC CHART |
Refer to Diagnostic Trouble Code Chart (Click here).
| |||||
| 19.CIRCUIT INSPECTION |
| |||||
| 20.IDENTIFICATION OF PROBLEM |
| |||||
| 21.REPAIR OR REPLACE |
| |||||
| 22.CONFIRMATION TEST |
| |||||