2014 Hilux · Service Manual TRANSMISSION

MONITOR DRIVE PATTERN

Troubleshooting · Vehicles built from Aug 2012

Versions by build date: Jun 2011 – Jul 2012 from Aug 2012


AUTOMATIC TRANSMISSION MONITOR DRIVE PATTERN

CAUTION:
Perform this drive pattern on a level surface and strictly observe the posted speed limits and traffic laws while driving.

HINT:
Performing this drive pattern is one method to simulate the automatic transmission malfunction detection conditions.
The DTCs may not be stored through ordinary, everyday driving. Also, DTCs may not be stored through this drive pattern.

  1. Preparation for driving

    1. Warm up the engine sufficiently (engine coolant temperature is 60°C (140°F) or higher).

    2. Drive the vehicle when the atmospheric temperature is -10°C (14°F) or higher.
      Malfunctions are not detected when the atmospheric temperature is below -10°C (14°F).

  2. Drive pattern

    1. Drive the vehicle through all the gears.
      Stop → 1st → 2nd → 3rd → 4th → 5th → 5th (lock-up ON).

    2. Repeat the above drive pattern 3 times or more.

      NOTICE:
      1. When using the intelligent tester, the monitor status can be checked in the Data List (Click here).
      2. In the event that the drive pattern must be interrupted (due to traffic conditions or other factors), the drive pattern can be resumed and, in most cases, the monitor can be completed.

C115866E15

HINT:
*: Drive at such a speed in the uppermost gear to engage lock-up. The vehicle can be driven at a speed lower than the speed shown in the above diagram under the lock-up condition.

← MONITOR DRIVE PATTERN (Jun 2011 – Jul 2012)PROBLEM SYMPTOMS TABLE (Jun 2011 – Jul 2012) →