P0973 Shift Solenoid "A" Control Circuit Low (Shift Solenoid Valve S1)
Diagnostic trouble codes · Vehicles built from Jun 2011
Also covers:
- P0974 Shift Solenoid "A" Control Circuit High (Shift Solenoid Valve S1)
DESCRIPTION
Shifting from 1st to 5th is performed in combination with the ON and OFF operation of the shift solenoid valves SL1, SL2, S1, S2 and SR, which is controlled by the ECM. If an open or short circuit occurs in the shift solenoid valves, the ECM controls the remaining normal shift solenoid valve to allow the vehicle to be operated safely (Click here).| DTC Code |
DTC Detection Condition |
Trouble Area |
| P0973 |
ECM detects short in solenoid valve S1 circuit 2 times when solenoid valve S1 is operated (1 trip detection logic) |
|
| P0974 |
ECM detects open in solenoid valve S1 circuit 2 times when solenoid valve S1 is not operated (1 trip detection logic) |
|
MONITOR DESCRIPTION
These DTCs indicate an open or short in the shift solenoid valve S1 circuit. When there is an open or short circuit in any shift solenoid valve circuit, the ECM detects the problem and illuminates the MIL and stores the DTC. When the shift solenoid valve S1 is ON, if resistance is 8 Ω or less, the ECM determines that there is a short in the shift solenoid valve S1 circuit.When the shift solenoid valve S1 is OFF, if resistance is 100 kΩ or more, the ECM determines that there is an open in the shift solenoid valve S1 circuit (Click here).
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- The shift solenoid valve S1 turns ON/OFF normally when the shift lever is on D:
ECM gear shift command
1st
2nd
3rd
4th
5th
Shift solenoid valve S1
ON
ON
OFF
OFF
OFF
| 1. INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE S1) |
Disconnect the E1 wire connector.

Measure the resistance of the wire connector.
- Standard resistance:
Tester Connection
Condition
Specified Condition
8 - Body ground
20°C (68°F)
11 to 15 Ω
|
|
||||
| OK | |
| 2. CHECK WIRE HARNESS (TRANSMISSION WIRE - ECM) |
Disconnect the E16 ECM connector.

Measure the resistance of the wire harness side connector.
- Standard resistance:
Tester Connection
Condition
Specified Condition
E16-11 (S1) - Body ground
20°C (68°F)
11 to 15 Ω
|
|
||||
| OK | ||
| ||
| 3. INSPECT SHIFT SOLENOID VALVE S1 |
![]() ![]() |
Remove the shift solenoid valve S1.
Measure the resistance of the solenoid valve.
- Standard resistance:
- 11 to 15 Ω at 20°C (68°F)
Connect the battery's positive (+) lead to the terminal of the solenoid connector, and the negative (-) lead to the solenoid body.
Check the operating noise of the solenoid valve.
- OK:
- Solenoid makes operating noise.
|
|
||||
| OK | ||
| ||

