P0818 Driveline Disconnect Switch Input Circuit
Diagnostic trouble codes · Vehicles built from Aug 2012
Versions by build date: Jun 2011 – Jul 2012 from Aug 2012
DESCRIPTION
The ECM detects the signal from the transfer neutral position switch.This DTC indicates that the transfer neutral position switch remains ON.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| P0818 |
Transfer neutral position switch remains ON while vehicle is running under following conditions for 30 sec. (2 trip detection logic):
|
|
MONITOR DESCRIPTION
The ECM detects whether or not the transfer shift lever is in neutral by monitoring the signal from the transfer neutral position switch.If the ECM detects that the transfer shift lever is in neutral under the following conditions, the ECM will conclude that there is a malfunction of the transfer neutral position switch:
- Transfer neutral position switch indicates that the transfer shift lever is in neutral.
- Transfer shift lever is in the H position.
- The vehicle is traveling at 25 km/h (16 mph) or more.
- The transfer neutral position switch has been ON for more than 30 seconds.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK WIRE HARNESS (NO. 2 TRANSFER INDICATOR SWITCH - BODY GROUND) |
![]() ![]() |
Disconnect the T5 switch connector.
Measure the resistance of the wire harness side connector.
- Standard resistance:
Transfer Connection
Specified Condition
T5-2 - Body ground
Below 1 Ω
|
|
||||
| OK | |
| 2. INSPECT NO. 2 TRANSFER INDICATOR SWITCH (TRANSFER NEUTRAL POSITION SWITCH) |
![]() ![]() |
Remove the transfer indicator switch.
Measure the resistance of the switch when pushing the ball at the tip of the switch.
- Standard resistance:
Tester Connection
Switch Condition
Specified Condition
1 - 2
Not pushed
10 kΩ or higher
1 - 2
Pushed
Below 1 Ω
|
|
||||
| OK | |
| 3. INSPECT COMBINATION METER |
Check the A/T P indicator light.
Disconnect the T5 switch connector.
Turn the ignition switch ON.
Connect the T5-1 terminal of the wire harness side connector to the body ground, and then check the A/T P indicator light.
- OK:
- A/T P indicator light illuminates.
|
|
||||
| OK | ||
| ||


