2014 Hilux · Service Manual TRANSMISSION

P0724 Brake Switch "B" Circuit High

Diagnostic trouble codes · Vehicles built from Jun 2011

DESCRIPTION

The purpose of this circuit is to prevent the engine from stalling while driving in the lock-up condition when the brakes are suddenly applied.
When the brake pedal is depressed, this switch sends signals to the ECM. Then the ECM cancels the operation of the lock-up clutch during braking.
DTC Code
DTC Detection Condition
Trouble Area
P0724
Stop light switch remains on while the vehicle is running (2 trip detection logic).
  1. Short in stop light switch signal circuit
  2. Stop light switch
  3. ECM

MONITOR DESCRIPTION

This DTC indicates that the stop light switch remains ON. When the stop light switch remains ON during STOP and GO driving, the ECM interprets this as a fault in the stop light switch. Then the MIL illuminates and the ECM stores the DTC.

WIRING DIAGRAM

C146704E17

INSPECTION PROCEDURE

HINT:
Using the Data List of the intelligent tester allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save time.
  1. Warm up the engine.
  2. Turn the ignition switch off.
  3. Connect the intelligent tester to the DLC3.
  4. Turn the ignition switch to ON and push the tester main switch on.
  5. Enter the following menus: Powertrain / Engine and ECT / Data List.
  6. Follow the instructions on the tester and read the Data List.

Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Stop Light Switch
Stop light switch status/
ON or OFF
Brake pedal is
  1. ON: Depressed
  2. OFF: Released
-

NOTICE:
In the table above, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


1. INSPECT STOP LIGHT SWITCH

  1. C170569E02
    Remove the S14 stop light switch.

  1. Measure the resistance of the switch.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Pin pushed (pedal released)
    10 kΩ or higher
    3 - 4
    Pin not pushed (pedal depressed)
    10 kΩ or higher
    1 - 2
    Pin not pushed (pedal depressed)
    Below 1 Ω
    3 - 4
    Pin pushed (pedal released)
    Below 1 Ω



NG
REPLACE STOP LIGHT SWITCH
OK


2. CHECK WIRE HARNESS (ECM - BATTERY)

  1. C192331E03
    Measure the voltage of the wire harness side connector.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E10-4 (STP) - Body ground
    Brake pedal is depressed
    11 to 14 V
    E10-4 (STP) - Body ground
    Brake pedal is released
    Below 1 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE ECM


← P0722/61 Output Speed Sensor Circuit No Signal (from Jun 2011)P0741 Torque Converter Clutch Solenoid Performance (Shift Solenoid Valve SL) (from Jun 2011) →