P0722/61 Output Speed Sensor Circuit No Signal
Diagnostic trouble codes · Vehicles built from Jun 2011
DESCRIPTION
The speed sensor (SP2) detects the rotation speed of the transmission output shaft and sends signals to the ECM. The ECM determines the vehicle speed based on these signals.AC voltage is generated in the speed sensor (SP2) coil as the rotor mounted on the output shaft rotates, and this voltage is sent to the ECM.
The gear shift point and lock-up timing are controlled by the ECM based on the signals from the output speed sensor and throttle position sensor.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| P0722/61 |
|
|
MONITOR DESCRIPTION
The output speed sensor (SP2) monitors the output shaft speed. The ECM controls the gear shift point and the lock-up timing based on the signals from the output speed sensor (SP2) and throttle position sensor.If the ECM detects no signal from the output speed sensor (SP2) even while the vehicle is moving, the ECM will conclude that the output shaft speed sensor (SP2) is malfunctioning. The ECM will illuminate the MIL and set the DTC.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK SPEED SENSOR (SP2) (INSTALLATION) |
Check the speed sensor installation.

- OK:
- Installation bolt is tightened properly and there is no clearance between sensor and transmission case.
|
|
||||
| OK | |
| 2. INSPECT SPEED SENSOR (SP2) |
![]() ![]() |
Disconnect the T7 sensor connector from the transmission.
Measure the resistance of the sensor.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
1 - 2
20°C (68°F)
560 to 680 Ω
- HINT:
-


- Reference: Inspect using an oscilloscope.
- Check the waveform of the ECM connector.
- OK:
- Refer to illustration
Item
Content
Tester Connection
E11-35 (SP2+) - E11-27 (SP2-)
Tool Setting
2 V/DIV., 2 msec./DIV.
Condition
Vehicle speed 20 km/h (12 mph)
|
|
||||
| OK | |
| 3. CHECK WIRE HARNESS (SPEED SENSOR (SP2) - ECM) |
Disconnect the E11 ECM connector.

Measure the resistance of the wire harness side connector.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E11-35 (SP2+) - E11-27 (SP2-)
20°C (68°F)
560 to 680 Ω
E11-35 (SP2+) - Body ground
20°C (68°F)
10 kΩ or higher
E11-27 (SP2-) - Body ground
20°C (68°F)
10 kΩ or higher
|
|
||||
| OK | ||
| ||

