2014 Hilux · Service Manual STEERING

INSTALLATION

Removal / installation · Vehicles built from Jun 2011


1. INSTALL VANE PUMP ASSEMBLY

  1. C123346E01
    Install the vane pump with the 2 bolts and nut.

    Torque:
    48 N*m{ 490 kgf*cm , 35 ft.*lbf } for bolt A
    63 N*m{ 642 kgf*cm , 47 ft.*lbf } for nut C

    HINT:
    Turn nut (C) while holding bolt (B).


2. INSTALL VANE PUMP PULLEY

  1. C123345E02
    Using SST, install the vane pump pulley to the vane pump.
    SST
    09960-10010   (09962-01000, 09963-01000)

    Torque:
    43 N*m{ 439 kgf*cm , 32 ft.*lbf }


3. CONNECT PRESSURE FEED TUBE ASSEMBLY
  1. Install a new gasket to the pressure feed tube.

  1. C123344
    Connect the pressure feed tube to the vane pump with the union bolt.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }

    HINT:
    Make sure the stopper of the pressure feed tube touches the vane pump.


4. CONNECT OIL RESERVOIR TO NO. 1 PUMP HOSE

  1. C123343
    Connect the hose to the vane pump with the clip.


5. INSTALL FAN AND GENERATOR V BELT (w/o Air Conditioning System)

  1. A115631E01
    Install the V belt.

  1. Using a bar, adjust the tension of the V belt.

  1. Tighten the bolts A and B.

    Torque:
    Bolt A:
    75 N*m{ 765 kgf*cm , 55 ft.*lbf }
    Bolt B:
    18 N*m{ 185 kgf*cm , 13 ft.*lbf }

  1. Check the deflection of the V belt (Click here).


6. INSTALL FAN AND GENERATOR V BELT (w/ Air Conditioning System)

  1. A115632E01
    Install the V belt.

  1. Tightening the bolt C, adjust the deflection of the V belt.

  1. Tighten the bolts A and B.

    Torque:
    Bolt A:
    75 N*m{ 765 kgf*cm , 55 ft.*lbf }
    Bolt B:
    18 N*m{ 185 kgf*cm , 13 ft.*lbf }

  1. Check the deflection of the V belt (Click here).


7. ADD POWER STEERING FLUID
(Click here)

8. BLEED POWER STEERING FLUID

9. CHECK FOR POWER STEERING FLUID LEAKS
← REASSEMBLY (from Jun 2011)COMPONENTS (from Jun 2011) →