C0226 SFR Solenoid Circuit
Diagnostic trouble codes · Vehicles built Jun 2011 – Jul 2012
Also covers:
- C0236 SFL Solenoid Circuit
- C0246 SRR Solenoid Circuit
- C0256 SRL Solenoid Circuit
- C1225 SM Solenoid Circuit
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
DESCRIPTION
These solenoids turn on when signals are received from the skid control ECU (brake actuator assembly) and control the pressure acting on the wheel cylinders to control the braking force.| DTC Code |
DTC Detection Condition |
Trouble Area |
| C0226 C0236 C0246 C0256 |
An open or short in the solenoid circuit continues for 0.05 seconds or more. |
|
| C1225 |
One of the following conditions is met:
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- After replacing the brake actuator assembly, perform calibration (Click here).
| 1. RECONFIRM DTC |
- HINT:
- These codes are stored when a problem is detected in the skid control ECU (brake actuator assembly). The solenoid circuits are in the skid control ECU (brake actuator assembly). Therefore, solenoid circuit inspections and solenoid unit inspections cannot be performed. Be sure to check if any DTCs are output before replacing the brake actuator assembly.
Clear the DTCs (Click here).
Turn the ignition switch off.
Start the engine.
Drive the vehicle at a speed of 20 km/h (12 mph) or more for 30 seconds or more.
Check if the same DTC is output (Click here).
Result Result
Proceed to
DTC is not output
A
DTC is output
for LHD
B
for RHD
C
- HINT:
- If a speed signal of 6 km/h (4 mph) or more is input to the skid control ECU (brake actuator assembly) with the ignition switch ON and the stop light switch off, the ECU performs self-diagnosis of the motor and solenoid circuits.
- If the normal system code is output (the trouble code is not output), slightly jiggle the connectors, wire harnesses and fuses of the skid control ECU (brake actuator assembly). Make sure that no DTCs are output.
- If any DTCs are output while jiggling a connector or wire harness of the skid control ECU (brake actuator assembly), inspect and repair the connector or wire harness. The DTCs were probably stored due to a bad connection of the connector terminal.
- If a speed signal of 6 km/h (4 mph) or more is input to the skid control ECU (brake actuator assembly) with the ignition switch ON and the stop light switch off, the ECU performs self-diagnosis of the motor and solenoid circuits.
|
|
||||
|
|
||||
| A | ||
| ||
