C1432 Steering Angle Sensor Power Source Voltage Malfunction
Diagnostic trouble codes · Vehicles built Aug 2012 – Jul 2013
Versions by build date: Jun 2011 – Oct 2011 Nov 2011 – Mar 2012 Apr 2012 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
Signals from the steering angle sensor (spiral cable sub-assembly) are sent to the skid control ECU (brake actuator assembly) via the CAN communication system.| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1432 |
A steering angle sensor power supply malfunction signal is received from the steering angle sensor. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Do not remove the steering angle sensor from the spiral cable sub-assembly.
- After replacing the spiral cable sub-assembly, confirm that the replacement part is of the correct specification.
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- Before disconnecting the connector, make sure that there are no problems with the connection.
- After disconnecting the connector, make sure that the connector case and terminals are not deformed or corroded.
- Do not remove the steering angle sensor from the spiral cable sub-assembly.
- HINT:
- When DTC U0073 and/or U0126 is output together with DTC C1432, inspect and repair the trouble areas indicated by DTC U0073 and/or U0126 first (Click here).
- When the speed sensor or yaw rate sensor assembly has trouble, DTCs for the steering angle sensor may be stored even when the steering angle sensor is normal. When DTCs for the speed sensor or the yaw rate and acceleration sensor are output together with DTCs for the steering angle sensor, inspect and repair the speed sensor and yaw rate sensor assembly first, and then inspect and repair the steering angle sensor.
- When DTC U0073 and/or U0126 is output together with DTC C1432, inspect and repair the trouble areas indicated by DTC U0073 and/or U0126 first (Click here).
| 1. CHECK TERMINAL VOLTAGE (BAT TERMINAL) |
Turn the ignition switch off.
Disconnect the steering angle sensor (spiral cable sub-assembly) connector.
Measure the voltage according to the value(s) in the table below.

- Standard Voltage:
Tester Connection
Condition
Specified Condition
S37-6 (BAT) - Body ground
Always
11 to 14 V
Text in Illustration *a
Front view of wire harness connector
(to Steering Angle Sensor [Spiral Cable Sub-assembly])
|
|
||||
| OK | |
| 2. CHECK TERMINAL VOLTAGE (IG TERMINAL) |
Turn the ignition switch off.
Disconnect the steering angle sensor (spiral cable sub-assembly) connector.
Measure the voltage according to the value(s) in the table below.

- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
S37-5 (IG) - Body ground
Ignition switch ON
11 to 14 V
Text in Illustration *a
Front view of wire harness connector
(to Steering Angle Sensor [Spiral Cable Sub-assembly])
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (ESS TERMINAL) |
Turn the ignition switch off.
Disconnect the steering angle sensor (spiral cable sub-assembly) connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
S37-2 (ESS) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
