U0073 Control Module Communication Bus OFF
Diagnostic trouble codes · Vehicles built Aug 2012 – Jul 2013
Also covers:
- U0100 Lost Communication with ECM / PCM
- U0123 Lost Communication with Yaw Rate Sensor Module
- U0124 Lost Communication with Lateral Acceleration Sensor Module
- U0126 Lost Communication with Steering Angle Sensor Module
Versions by build date: Jun 2011 – Oct 2011 Nov 2011 – Mar 2012 Apr 2012 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The skid control ECU (brake actuator assembly) receives signals from the ECM, steering angle sensor (spiral cable sub-assembly) and yaw rate sensor assembly via the CAN communication system.| DTC Code |
DTC Detection Condition |
Trouble Area |
| U0073 |
One of the following conditions is met:
|
CAN communication system |
| U0100 |
Either condition is met:
|
CAN communication system |
| U0123 |
Either condition is met:
|
CAN communication system |
| U0124 |
Either condition is met:
|
CAN communication system |
| U0126 |
Either condition is met:
|
CAN communication system |
INSPECTION PROCEDURE
| 1. RECONFIRM DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Start the engine.
Drive the vehicle at a speed of 15 km/h (9 mph) or more and turn the steering wheel to the right and left.
Check for DTCs (Click here).
- HINT:
- If a CAN communication system DTC and the relevant sensor DTCs are output simultaneously, troubleshoot the relevant sensor DTCs (for ABS and VSC) after the CAN communication system returns to normal.
Result Result
Proceed to
DTC (relating to CAN communication system) is output
A
DTC (relating to ABS and/or VSC system) is output
B
DTC is not output
C
|
|
||||
|
|
||||
| A | ||
| ||
