TS and CG Terminal Circuit
Circuit diagnosis · Vehicles built Aug 2012 – Jul 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
DESCRIPTION
Sensor check mode can be entered by connecting terminals TS and CG of the DLC3 and turning the ignition switch from off to ON.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- After replacing the brake actuator assembly, perform calibration (Click here).
- Before disconnecting the connector, make sure that there are no problems with the connection.
- After disconnecting the connector, make sure that the connector case and terminals are not deformed or corroded.
| 1. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DLC3) |
 |
Turn the ignition switch off.
Disconnect the skid control ECU (brake actuator assembly) connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
S35-33 (TS) - D1-12 (TS)
|
Always
|
Below 1 Ω
|
S35-33 (TS) - Body ground
|
Always
|
10 kΩ or higher
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| 2. CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND) |
 |
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
D1-4 (CG) - Body ground
|
Always
|
Below 1 Ω
|
Result
Result
|
Proceed to
|
NG
|
A
|
OK
|
for LHD
|
B
|
for RHD
|
C
|
|
B |
 |
|
|
|
|
C |
 |
|
|
|
| A |
|
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|