INSPECTION
Inspection · Vehicles built from Jun 2011
| INSPECT FUEL PUMP |
Check the fuel pump resistance.

Using an ohmmeter, measure the resistance between terminals 4 and 5.
- Standard resistance:
- 0.2 to 3.0 at 20°C (68°F)
Check fuel pump operation.
Apply battery voltage to terminals 4 and 5. Check that the pump operates.
- NOTICE:
- This test must be completed within 10 seconds to prevent the coil from burning out.
- Keep fuel pump as far away from the battery as possible.
- Always turn on and off the voltage on the battery side, not the fuel pump side.
- This test must be completed within 10 seconds to prevent the coil from burning out.
| INSPECT FUEL PUMP RELAY ASSEMBLY |
![]() ![]() |
Check the resistance.
Using an ohmmeter, check the resistance between each terminal.
- Standard resistance:
Tester Connection
Specified Condition
1 - 2
3 - 4
Below 1 Ω
3 - 5
10 kΩ or higher
Using an ohmmeter, check the resistance between terminals 3 and 5 when the battery voltage is applied across terminals 1 and 2.
- Specified condition:
- Below 1 Ω

