REMOVAL
Removal / installation · Vehicles built from Jun 2011
| 1. REMOVE FUEL TANK ASSEMBLY |
Remove the fuel tank from the body (Click here).
| 2. REMOVE FUEL SUCTION WITH PUMP AND GAUGE ASSEMBLY FROM FUEL TANK |
Remove the fuel gauge tube from the fuel tank.
- NOTICE:
- Be careful not to bend the arm of the fuel sender gauge.
Remove the gasket from the fuel tank.
| 3. REMOVE FUEL SENDER GAUGE |
Disconnect the fuel sender gauge connector.

Press down on the sender gauge claw labeled A. Then slide the sender gauge upward.
| 4. REMOVE NO. 1 FUEL SUB TANK |
Disconnect the fuel pump connector.

Using a small screwdriver, detach the claw on the end of the tube from the claw hole. Disconnect the tube from the 2 clamps.

Remove the sub tank cap.

Disconnect the 2 fuel tubes and fuel pump harness.
Using a screwdriver, detach the 3 claws from the claw holes and remove the sub tank cap.

- HINT:
- Tape the screwdriver tip before use.
Using needle-nose pliers, remove the 2 E-rings.

- HINT:
- Slightly lower the sub tank cap to remove the E-rings.
Remove the 2 springs.
Using a screwdriver, detach the 2 claws from the claw holes and remove the fuel sub tank.

- NOTICE:
- Do not damage the fuel sub tank.
- HINT:
- Tape the screwdriver tip before use.
| 5. REMOVE FUEL PUMP |
Using a screwdriver, detach the 3 claws from the claw holes and disconnect the fuel pump and suction filter assembly.

- HINT:
- Tape the screwdriver tip before use.
Remove the fuel pump harness.

Remove the O-ring from the fuel pump.

| 6. REMOVE NO. 1 FUEL SUCTION SUPPORT |
Using a screwdriver, detach the 2 claws from the claw holes and remove the fuel suction support.

- HINT:
- Tape the screwdriver tip before use.
