2014 Hilux · Service Manual RESTRAINTS

B1000/31 Center Airbag Sensor Assembly Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2014

Versions by build date: Jun 2011 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The center airbag sensor consists of an airbag sensor, safing sensor, drive circuit, diagnosis circuit, ignition control circuit, etc.
If the center airbag sensor receives signals from the airbag sensor, it determines whether the SRS should be activated.
DTC B1000/31 is stored when a malfunction is detected in the center airbag sensor.
DTC Code
DTC Detection Condition
Trouble Area
B1000/31
A center airbag sensor malfunction.
Center airbag sensor assembly

HINT:
When a trouble code is output simultaneously with B1000/31, repair the malfunction indicated by the other code first.


INSPECTION PROCEDURE


1. CHECK DTC
  1. Turn the ignition switch to ON, and wait for at least 60 seconds.

  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    DTC B1000/31 and other DTCs are output
    A
    DTC B1000/31 is output
    B

    NOTICE:
    If only DTC B1000/31 is output, do not clear the DTCs. Instead, immediately replace the center airbag sensor assembly.

    HINT:
    If any DTCs other than DTC B1000/31 are output, troubleshoot those DTCs first.



A
GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
B

REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)


← B1000/31 Center Airbag Sensor Assembly Malfunction (Aug 2013 – Jul 2014)B1610/13 Front Airbag Sensor RH Circuit Malfunction (Jun 2011 – Jul 2013) →