HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Jun 2011 – Jul 2013
Versions by build date: Jun 2011 – Jul 2013 from Aug 2013
- HINT:
- Use these procedures to troubleshoot the supplemental restraint system.
- *: Use the intelligent tester.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| NEXT |
|
 |
|
|
| 2.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| NEXT |
|
 |
|
|
Check for DTC and note any codes that are output.
Delete the DTC.
Recheck for DTC.
- Result:
Result
|
Proceed to
|
DTC does not reoccur
|
A
|
DTC reoccurs
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
- Result:
Result
|
Proceed to
|
Fault is not listed in problem symptoms table
|
A
|
Fault is listed in problem symptoms table
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
| 5.OVERALL ANALYSIS AND TROUBLESHOOTING |
On-vehicle inspection (Click here), (Click here), (Click here).
Terminals of ECU (Click here).
| NEXT |
|
 |
|
|
| NEXT |
|
 |
|
|
| NEXT |
|
 |
|
|