2014 Hilux · Service Manual RESTRAINTS

SRS Warning Light does not Come ON

Circuit diagnosis · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2013 from Aug 2013

DESCRIPTION

The SRS warning light is located on the combination meter. When the SRS is normal, the SRS warning light illuminates for approximately 6 seconds after the ignition switch is turned from OFF to ON, and then turns OFF automatically. If there is a malfunction in the SRS, the SRS warning light illuminates to inform the driver. When terminals TC and CG of the DLC3 are connected, the DTCs are communicated through SRS warning light blinking patterns.

WIRING DIAGRAM

Refer to "SRS Warning Light Remains on" (Click here).

INSPECTION PROCEDURE

CAUTION:
Be sure to perform the following procedures before troubleshooting to avoid unexpected airbag deployment.

  1. Turn the ignition switch OFF.
  2. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
  3. Disconnect the connector from the center airbag sensor.
  4. Disconnect the connector from the steering pad.

1. CHECK CONNECTION OF CONNECTORS
  1. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

  1. Check that the connectors are properly connected to the center airbag sensor and combination meter.

    OK:
    Connectors are connected.



NG
CONNECT CONNECTORS
OK


2. CHECK COMBINATION METER ASSEMBLY
H100390E27
  1. Disconnect the C25 meter connector.

  1. Turn the ignition switch ON.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Specified Condition
    C25-21 - Body ground
    8 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3. CHECK SRS WARNING LIGHT OPERATION
  1. Replace the center airbag sensor.

  1. Check that the SRS warning light illuminates normally.

    OK:
    SRS warning light illuminates normally.



NG
REPLACE COMBINATION METER ASSEMBLY
OK


4. REPLACE CENTER AIRBAG SENSOR ASSEMBLY


NG
REPLACE COMBINATION METER ASSEMBLY
OK

END


← SRS Warning Light does not Come ON (Jun 2011 – Jul 2013)TC and CG Terminal Circuit (Jun 2011 – Jul 2013) →