TC and CG Terminal Circuit
Circuit diagnosis · Vehicles built Jun 2011 – Jul 2013
Versions by build date: Jun 2011 – Jul 2013 from Aug 2013
DESCRIPTION
DTC output mode is set by connecting terminals TC and CG of the DLC3. The DTCs are communicated through SRS warning light blinking patterns.- HINT:
- When one or more of the warning lights blinks continuously, the cause may be a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU.
WIRING DIAGRAM


INSPECTION PROCEDURE
- CAUTION:
- Be sure to perform the following procedures before troubleshooting to avoid unexpected airbag deployment.
- Turn the ignition switch OFF.
- Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
| 1. CHECK WIRE HARNESS (DLC3 - CENTER AIRBAG SENSOR AND BODY GROUND) |
![]() ![]() |
Disconnect the A14 ECU connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
D1-13 (TC) - A14-15 (TC)
Below 1 Ω
D1-4 (CG) - Body ground
Below 1 Ω
A14-15 (TC) - Body ground
1 MΩ or higher
|
|
||||
| OK | ||
| ||

