2014 Hilux · Service Manual RESTRAINTS

TC and CG Terminal Circuit

Circuit diagnosis · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2013 from Aug 2013

DESCRIPTION

DTC output mode is set by connecting terminals TC and CG of the DLC3. The DTCs are communicated through SRS warning light blinking patterns.

HINT:
When one or more of the warning lights blinks continuously, the cause may be a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU.


WIRING DIAGRAM

C215579E05

INSPECTION PROCEDURE

CAUTION:
Be sure to perform the following procedures before troubleshooting to avoid unexpected airbag deployment.

  1. Turn the ignition switch OFF.
  2. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

1. CHECK WIRE HARNESS (DLC3 - CENTER AIRBAG SENSOR AND BODY GROUND)
H100393E02
  1. Disconnect the A14 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    D1-13 (TC) - A14-15 (TC)
    Below 1 Ω
    D1-4 (CG) - Body ground
    Below 1 Ω
    A14-15 (TC) - Body ground
    1 MΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE CENTER AIRBAG SENSOR ASSEMBLY


← TC and CG Terminal Circuit (Jun 2011 – Jul 2013)COMPONENTS (from Jun 2011) →