B2793 Transponder Chip Malfunction
Diagnostic trouble codes · Vehicles built from Jun 2011
Also covers:
- B2794 Unmatched Encryption Code
- B2795 Unmatched Key Code
DESCRIPTION
DTC B2793 is stored when a malfunction is found in the key during key code registration or a key code is not registered normally. Replace the key if key code registration cannot be performed normally and this DTC is output.DTC B2794 is stored when a key with an incomplete key code is inserted into the ignition key cylinder.
DTC B2795 is stored when a key with a key code that is not registered in the ECU is inserted into the ignition key cylinder.
| DTC Code |
DTC Detection Condition |
Trouble Area |
DTC Output Confirmation Operation |
| B2793 |
A transponder chip malfunction (1 trip detection logic*). |
Key |
Insert the key into the ignition key cylinder. |
| B2794 |
A key with an incomplete key code is inserted into the ignition key cylinder (1 trip detection logic*). |
Key |
Insert the key into the ignition key cylinder. |
| B2795 |
A key with a different vehicle serial number is inserted into the ignition key cylinder (1 trip detection logic*). |
Key |
Insert the key into the ignition key cylinder. |
- *: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected |
Fail-safe Operation when Malfunction Detected |
| Engine cannot be started. |
- |
| DTC Code |
Data List and Active Test |
| B2793 |
Abnormal Status |
| B2794 |
Different Encrypt Code |
| B2795 |
Different Serial Number |
INSPECTION PROCEDURE
- NOTICE:
- When replacing the key, refer to the Service Bulletin.
- After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.
- When replacing the key, refer to the Service Bulletin.
| 1. REREGISTER KEY |
Clear the DTC (Click here).
Reregister the key, and check that the engine starts with the key.
- OK:
- Engine starts.
|
|
||||
| OK | ||
| ||
