2014 Hilux · Service Manual DRIVE LINE

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. REMOVE SLIDING SHAFT BOOT
  1. Place matchmarks on the propeller shaft and sleeve yoke.

  1. Using a side cutter or pliers, remove the small and large boot clamps.

  1. Disconnect the boot from the sleeve yoke.

  1. Remove the sleeve yoke, and then remove the boot from the propeller shaft.


2. REMOVE UNIVERSAL JOINT SPIDER ASSEMBLY

F052432E01
  1. Place matchmarks on the flange yoke and sleeve yoke.

  1. F052433E01
    Using a brass bar and hammer, slightly tap in the spider bearing outer races.

  1. Using needle nose pliers, remove the 4 snap rings from the grooves.

  1. F015025E01
    Clamp the propeller shaft in a vise between aluminum plates.

  1. Using SST, push the sleeve yoke side spider bearing until: 1) the spider almost touches the sleeve yoke or propeller shaft, and 2) the spider bearing on the opposite side is partially pushed out.

    SST
    09332-25010  

    HINT:
    Before installing SST, sufficiently raise the part labeled A. If part A is too low, SST may be difficult to install.

  1. F044192E01
    Clamp the pushed out spider bearing outer race in a vise and tap the propeller shaft to remove the spider bearing.

    NOTICE:
    Do not tap the shaft tube.

    HINT:
    Remove the spider bearing from the opposite side of the spider using the same procedure.

  1. Separate the flange yoke and spider from the sleeve yoke.

  1. F015030E01
    Reinstall the 2 removed spider bearings to the spider and clamp the spider bearings in a vise.

  1. Using SST, push the flange yoke side spider bearing until: 1) the spider almost touches the flange yoke, and 2) the spider bearing on the opposite side is partially pushed out.

    SST
    09332-25010  

    HINT:
    Before installing SST, sufficiently raise the part labeled A. If part A is too low, SST may be difficult to install.

  1. F044193E01
    Clamp the pushed out spider bearing outer race in a vise and tap the flange yoke to remove the spider bearing.

    HINT:
    Remove the spider bearing from the opposite side of the spider using the same procedure.

  1. Separate the spider from the flange yoke.

    HINT:
    Perform the removal of the other universal joint spider using the same procedures.

← REMOVAL (from Jun 2011)INSPECTION (from Jun 2011) →