2014 Hilux · Service Manual DRIVE LINE

REMOVAL

Removal / installation · Vehicles built from Jun 2011


1. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (for 2WD)

F050137E01
  1. Place matchmarks on the propeller shaft flange and differential flange.

  1. Remove the 4 nuts, 4 bolts and 4 washers, and disconnect the propeller shaft.

  1. A098693E01
    Remove the center support bearing's 2 set bolts and 2 plates from the frame crossmember.

  1. C098710E01
    Pull out the propeller shaft.

  1. Install SST in the extension housing to prevent oil leakage.

    SST
    09325-40010  


2. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (for 4WD)

C098699E01
  1. Place matchmarks on the propeller shaft flange and transfer flange.

  1. Remove the 4 nuts and 4 washers, and disconnect the propeller shaft.

  1. C098700E01
    Place matchmarks on the propeller shaft flange and differential flange.

  1. A098693E01
    Remove the 4 nuts, 4 bolts and 4 washers.

  1. Remove the center support bearing's 2 set bolts and 2 plates from the frame crossmember.

  1. Remove the propeller shaft.

← COMPONENTS (from Jun 2011)DISASSEMBLY (from Jun 2011) →