INSTALLATION
Removal / installation · Vehicles built from Jun 2011
- HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- A bolt without a torque specification is shown in the standard bolt chart (Click here).
- Use the same procedures for the RH side and LH side.
| 1. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH |
![]() ![]() |
Coat the spline of the inboard joint with differential oil.
Align the shaft splines and tap in the drive shaft with a brass bar and hammer.
- HINT:
- Whether or not the inboard joint shaft is contacting the pinion shaft can be determined by driving the joint shaft. Check the operating sound and feel of the shaft.
- NOTICE:
- Set the snap ring with its open side facing downward.
- Be careful not to damage the oil seal.
- Set the snap ring with its open side facing downward.
| 2. INSTALL FRONT SPEED SENSOR |
![]() ![]() |
Install the speed sensor with the bolt.
- Torque:
- 8.5 N*m{ 87 kgf*cm , 75 in.*lbf }
Connect the 2 clamps.
Install the speed sensor wire harness to the steering knuckle with the bolt.
- Torque:
- 32 N*m{ 326 kgf*cm , 24 ft.*lbf }
| 3. CONNECT FRONT SUSPENSION LOWER ARM ASSEMBLY WITH ATTACHMENT LH |
![]() ![]() |
Connect the steering knuckle to the lower suspension arm with the 2 bolts.
- Torque:
- 160 N*m{ 1,632 kgf*cm , 118 ft.*lbf }
| 4. CONNECT TIE ROD END SUB-ASSEMBLY LH |
![]() ![]() |
Connect the tie rod end to the steering knuckle with the nut.
- Torque:
- 91 N*m{ 928 kgf*cm , 67 ft.*lbf }
Install a new cotter pin.
- NOTICE:
- If the holes for the cotter pin are not aligned, tighten the nut an additional 60°.
| 5. INSTALL FRONT AXLE HUB NUT |
![]() ![]() |
Install the hub nut.
- Torque:
- 235 N*m{ 2,396 kgf*cm , 173 ft.*lbf }
Install the adjusting cap and a new cotter pin.
- NOTICE:
- If the holes for the cotter pin are not aligned, tighten the nut an additional 60°.
| 6. INSTALL FRONT AXLE HUB GREASE CAP |
Install a new grease cap to the axle hub.
| 7. ADD DIFFERENTIAL OIL |
| 8. INSPECT DIFFERENTIAL OIL |
| 9. INSTALL FRONT WHEEL |
- Torque:
- 105 N*m{ 1,071 kgf*cm , 77 ft.*lbf }
| 10. CHECK ABS SPEED SENSOR SIGNAL |
Check the ABS speed sensor signal (Click here).






