REASSEMBLY
Removal / installation · Vehicles built from Jun 2011
- HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- Use the same procedures for the RH side and LH side.
| 1. INSTALL FRONT AXLE HUB DUST SEAL |
![]() ![]() |
Using a screwdriver and hammer, tap in a new dust seal.
- NOTICE:
- Do not damage the dust seal.
| 2. INSTALL FRONT DRIVE SHAFT DUST COVER |
![]() ![]() |
Using SST and a press, press in a new dust cover.
- SST
- 09527-10011
| 3. INSTALL HOLE SNAP RING |
Install a new snap ring.
| 4. INSTALL OUTBOARD JOINT BOOT |
![]() ![]() |
- HINT:
- Before installing the boots, wrap the spline of the drive shaft with vinyl tape to prevent the boots from being damaged.
Temporarily install a new outboard joint boot (with 2 boot clamps) to the drive shaft.
Pack the outboard joint and boot with grease from a boot kit.
- Standard grease capacity:
- 60 to 80 g (2.2 to 2.8 oz.)
| 5. INSTALL FRONT AXLE OUTBOARD JOINT BOOT CLAMP |
![]() ![]() |
Mount the drive shaft in a soft vise.
Secure the outboard joint large boot clamp onto the boot.
Place SST onto the clamp.
- SST
- 09521-24010
Tighten SST so that the boot clamp is pinched.
- NOTICE:
- Do not overtighten SST.
Using SST, adjust the clearance of the clamp.

- SST
- 09240-00020
- Standard clearance:
- 0.8 mm (0.0314 in.) or less
For the outboard joint small boot clamp, use the same procedures described above.
| 6. INSTALL INBOARD JOINT BOOT |
Install a new inboard joint boot to the outboard joint shaft.
| 7. INSTALL INBOARD JOINT |
![]() ![]() |
Align the matchmarks of the tripod and outboard joint.
- HINT:
- Place the beveled side of the tripod axial spline toward the outboard joint.
Using a brass bar and hammer, tap the tripod onto the outboard joint.
- NOTICE:
- Do not tap the rollers.
Using a snap ring expander, install a new snap ring.
Pack the inboard joint and boot with grease from a boot kit.
- Standard grease capacity:
- 121 to 141 g (4.3 to 4.9 oz.)
Align the matchmarks of the inboard joint and outboard joint.
Install the inboard joint to the outboard joint.
| 8. INSTALL FRONT AXLE INBOARD JOINT BOOT CLAMP |
![]() ![]() |
Using pliers, compress the large clamp and attach the claws.
Secure the boot clamp onto the boot.

Place SST onto the clamp.
- SST
- 09521-24010
Tighten SST so that the boot clamp is pinched.
- NOTICE:
- Do not overtighten the SST.
Using SST, adjust the clearance of the small boot clamp.

- SST
- 09240-00020
- Standard clearance:
- 0.8 mm (0.0314 in.) or less
| 9. INSPECT FRONT DRIVE SHAFT ASSEMBLY LH |
![]() ![]() |
*1:
Check that there is no excessive play in the outboard joint.
*2:
Check that the inboard joint slides smoothly in the thrust direction.
*3:
Check that there is no excessive play in the radial direction of the inboard joint.
*4:
Check the boots for damage.







