2014 Hilux · Service Manual SUSPENSION & AXLE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jun 2011


CHECK REAR AXLE SHAFT BEARING

F049761E01
  1. Remove the rear wheel.

  1. Remove the brake drum.

  1. Inspect the axle shaft backlash.

    1. Using a dial indicator, check the backlash near the center of the axle shaft.

      Maximum backlash:
      0.5 mm (0.0197 in.)

      If the backlash is greater than the maximum, replace the bearing.

  1. F049760E01
    Inspect the axle shaft deviation.

    1. Using a dial indicator, check the deviation at the surface of the axle shaft.

      Maximum deviation:
      0.1 mm (0.0039 in.)

      If the deviation is greater than the maximum, replace the bearing.

← COMPONENTS (from Jun 2011)REMOVAL (from Jun 2011) →