2014 Hilux · Service Manual BRAKE

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Jun 2011 – Jul 2013

Versions by build date: Jun 2011 – Jul 2013 from Aug 2013

HINT:
  1. Use these procedures to troubleshoot the Anti-lock Brake System (ABS).
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.CHECK AND CLEAR DTC*
      NEXT

      4.PROBLEM SYMPTOM CONFIRMATION

        Result:
        Result
        Proceed to
        Symptom does not occur
        A
        Symptom occurs
        B


      B.
      A

      5.SYMPTOM SIMULATION
        NEXT

        6.CHECK FOR DTC*

          Result:
          Result
          Proceed to
          DTC is not output
          A
          DTC is output
          B


        B.
        A

        7.PROBLEM SYMPTOMS TABLE

          Result:
          Result
          Proceed to
          Fault is not listed in problem symptoms table
          A
          Fault is listed in problem symptoms table
          B


        B.
        A

        8.OVERALL ANALYSIS AND TROUBLESHOOTING
        1. Terminals of ECU (Click here)

        2. Data List / Active Test (Click here)

        NEXT

        9.CHECK FOR FLUID LEAKAGE
          NEXT

          10.REPAIR OR REPLACE
            NEXT

            11.CONFIRMATION TEST
              NEXT

              ← SYSTEM DESCRIPTION (from Jun 2011)HOW TO PROCEED WITH TROUBLESHOOTING (from Aug 2013) →