Disconnect the antenna connector from the radio receiver assembly.
With the radio receiver assembly connector connected, turn the ignition switch to ACC.
Turn on the radio and choose the AM mode.
Place a flat-head screwdriver or a piece of metal, such as a thin wire, on the antenna jack of the radio receiver assembly. Check that noise is heard from the speakers.
OK:
Noise is heard.
for Plug Type:
Remove the antenna plug of the radio receiver assembly.
With the radio receiver assembly connector connected, turn the ignition switch to ACC.
Turn on the radio and choose the AM mode.
Place a flat-head screwdriver or a piece of metal, such as a thin wire, on the antenna jack of the radio receiver assembly. Check the noise is heard from the speakers.