C1249/49 Open in Stop Light Switch Circuit
Diagnostic trouble codes · Vehicles built from Jun 2011
DESCRIPTION
This circuit recognizes brake operation by sending a stop light signal to the skid control ECU.| DTC No. |
DTC Detection Condition |
Trouble Area |
| C1249/49 |
Both conditions continue for at least 0.3 seconds:
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK STOP LIGHT SWITCH (OPERATION) |
Check that the stop light illuminates when the brake pedal is depressed, and turns off when the brake pedal is released.
- OK:
Condition
Stop Light Condition
Brake pedal depressed
Illuminates
Brake pedal released
Turns off
|
|
||||
| OK | |
| 2. CHECK WIRE HARNESS (SKID CONTROL ECU - STOP LIGHT SWITCH) |
![]() ![]() |
Disconnect the S2 ECU connector.
Disconnect the S14 stop light switch connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
S2-10 (STP) - S14-1
Below 1 Ω
|
|
||||
| OK | |
| 3. CHECK IF DTC OUTPUT RECURS |
Clear the DTCs.
Drive the vehicle at approximately 30 km/h (19 mph) or more for 60 seconds or more.
Check for DTCs.
Result Result
Proceed to
DTC is output
A
DTC is not output
B
|
|
||||
| A | ||
| ||
| 4. INSPECT STOP LIGHT SWITCH ASSEMBLY |
![]() ![]() |
Disconnect the switch connector.
Measure the resistance of the stop light switch.
- Standard resistance:
Tester Connection
Switch Condition
Specified Condition
1 - 2
Pin not pushed
Below 1 Ω
1 - 2
Pin pushed
10 kΩ or higher
3 - 4
Pin not pushed
10 kΩ or higher
3 - 4
Pin pushed
Below 1 Ω
|
|
||||
| OK | |
| 5. CHECK WIRE HARNESS (SKID CONTROL ECU - BATTERY) |
![]() ![]() |
Disconnect the S2 ECU connector.
Measure the voltage of the wire harness side connector.
- Standard voltage:
Tester Connection
Condition
Specified Condition
S2-10 (STP) - Body ground
Brake pedal depressed
8 to 14 V
S2-10 (STP) - Body ground
Brake pedal released
Below 1 V
|
|
||||
| OK | |
| 6. CHECK IF DTC OUTPUT RECURS |
Clear the DTCs.
Drive the vehicle at approximately 30 km/h (19 mph) or more for 60 seconds or more.
Check for DTCs.
Result Result
Proceed to
DTC is output
A
DTC is not output
B
|
|
||||
| A | ||
| ||



