2014 Hilux · Service Manual BRAKE

TC and CG Terminal Circuit

Circuit diagnosis · Vehicles built from Jun 2011

DESCRIPTION

Connecting terminals TC and CG of the DLC3 causes the ECU to display DTCs through ABS warning light blinking patterns.

WIRING DIAGRAM

C108882E01

INSPECTION PROCEDURE


1. CHECK WIRE HARNESS (DLC3 - SKID CONTROL ECU AND BODY GROUND)
C108907E01
  1. Disconnect the S2 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    D1-4 (CG) - Body ground
    Below 1 Ω
    D1-13 (TC) - S2-16 (TC)
    Below 1 Ω
    S2-16 (TC) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE BRAKE ACTUATOR ASSEMBLY


← ABS Warning Light does not Come ON (from Jun 2011)TS and CG Terminal Circuit (from Jun 2011) →