2014 Hilux · Service Manual BRAKE

ABS Warning Light does not Come ON

Circuit diagnosis · Vehicles built from Jun 2011

DESCRIPTION

If the skid control ECU detects a malfunction, it will prohibit ABS control, illuminate the ABS warning light and store a DTC. Connecting terminals TC and CG of the DLC3 causes the ECU to display DTCs through ABS warning light blinking patterns.

WIRING DIAGRAM

C108877E01

INSPECTION PROCEDURE


1. CHOOSE DIAGNOSIS METHOD
  1. Choose the diagnosis method.

    Method 
    Method
    Proceed to
    Using intelligent tester
    A
    Not using intelligent tester
    B



B
Go to step 3
A


2. PERFORM ACTIVE TEST BY INTELLIGENT TESTER (ABS WARNING LIGHT)
  1. Select the Active Test, generate a control command, and then check that the ABS warning light operates.

Skid control ECU 
Item
Vehicle Condition / Test Details
Diagnostic Note
ABS Warning Light
Turn ABS warning light ON / OFF
Observe combination meter

OK:
ABS warning light turns on or off.



OK
REPLACE BRAKE ACTUATOR ASSEMBLY
NG


3. CHECK ABS WARNING LIGHT
C108884E08
  1. Disconnect the S2 ECU connector.

  1. Turn the ignition switch ON.

  1. Using a service wire, connect terminal WA to GND1 or GND2 of the S2 ECU connector. Check the ABS warning light.

    OK:
    ABS warning light turns off.

  1. Turn the ignition switch OFF.

  1. Remove the service wire.

  1. Turn the ignition switch ON. Check the ABS warning light.

    OK:
    ABS warning light illuminates.



OK
REPLACE BRAKE ACTUATOR ASSEMBLY
NG


4. CHECK WIRE HARNESS (SKID CONTROL ECU - COMBINATION METER)
C108898E30
  1. Disconnect the S2 ECU connector.

  1. Disconnect the C25 meter connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    S2-13 (WA) - C25-38
    Below 1 Ω
    S2-13 (WA) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


5. CHECK INDICATOR AND WARNING LIGHT
  1. Check if the indicators and warning lights (SRS, etc.) other than the ABS warning light operate normally.

Result 
Result
Proceed to
Indicators and warning lights operate normally
A
Indicators and warning lights do not operate normally
B


B
CHECK COMBINATION METER ASSEMBLY (COMBINATION METER CIRCUIT)
A

REPLACE COMBINATION METER ASSEMBLY


← ABS Warning Light Remains ON (from Aug 2013)TC and CG Terminal Circuit (from Jun 2011) →