TC and CG Terminal Circuit
Circuit diagnosis · Vehicles built from Jun 2011
DESCRIPTION
Connecting terminals TC and CG of the DLC3 causes the ECU to display DTCs through ABS warning light blinking patterns.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK WIRE HARNESS (DLC3 - SKID CONTROL ECU AND BODY GROUND) |
![]() ![]() |
Disconnect the S2 ECU connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
D1-4 (CG) - Body ground
Below 1 Ω
D1-13 (TC) - S2-16 (TC)
Below 1 Ω
S2-16 (TC) - Body ground
10 kΩ or higher
|
|
||||
| OK | ||
| ||

