2014 Hilux · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built Aug 2012 – Jul 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

HINT:
  1. The procedures listed below are for the LH side.
  2. Other than areas where instructions are provided, use the same procedures for the LH side and RH side.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE FRONT WHEEL

3. REMOVE FRONT SPEED SENSOR LH

  1. Disconnect the connector.

    C188015E01

  1. Detach the 2 clamps and the connector.

  1. C189975E01
    Detach the clamp and remove the bolt and harness clamp.

  1. C188000E01
    Remove the bolt and harness clamp.

  1. C187999E01
    Remove the 3 bolts, 2 harness clamps and speed sensor.

    NOTICE:
    Keep the sensor tip and sensor installation hole free from foreign matter.

← REMOVAL (Jun 2011 – Jul 2012)REMOVAL (from Aug 2013) →