INSTALLATION
Removal / installation · Vehicles built Aug 2012 – Jul 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
| 1. INSTALL REAR SPEED SENSOR |
Install the speed sensor RH with the bolt.


- Torque:
- 8.5 N*m{ 87 kgf*cm , 75 in.*lbf }
- NOTICE:
- Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
- While inserting the speed sensor into the axle housing hole, do not strike or damage the sensor tip.
- After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the axle housing.
- Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
Install the harness clamp with the bolt.
- Torque:
- 8.5 N*m{ 87 kgf*cm , 75 in.*lbf }
- NOTICE:
- When installing the clamp, do not twist the wire harness.
- Make sure the clamp rotation stopper touches the installation position.
- When installing the clamp, do not twist the wire harness.
Attach the 2 clamps.
- NOTICE:
- When attaching the clamps, do not twist the wire harness.
Attach the connector.
- NOTICE:
- Securely attach the connector.
- When attaching the connector, do not twist the wire harness.
- Securely attach the connector.
Connect the connector.
- NOTICE:
- Securely connect the connector.
- When connecting the connector, do not twist the wire harness.
- Securely connect the connector.
Install the speed sensor LH with the bolt.


- Torque:
- 8.5 N*m{ 87 kgf*cm , 75 in.*lbf }
- NOTICE:
- Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
- While inserting the speed sensor into the axle housing hole, do not strike or damage the sensor tip.
- After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the axle housing.
- Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
Install the 2 harness clamps with the 2 bolts.
- Torque:
- for bolt A:
- 8.5 N*m{ 87 kgf*cm , 75 in.*lbf }
- for bolt B:
- 32 N*m{ 326 kgf*cm , 24 ft.*lbf }
- NOTICE:
- When installing the clamps, do not twist the wire harness.
- Make sure the clamp rotation stopper touches the installation position.
- When installing the clamps, do not twist the wire harness.
Attach the clamp.
- NOTICE:
- When attaching the clamp, do not twist the wire harness.
| 2. INSTALL REAR WHEEL |
- Torque:
- for Steel Wheel (2WD):
- 152 N*m{ 1550 kgf*cm , 112 ft.*lbf }
- for Aluminum Wheel (2WD):
- 121 N*m{ 1234 kgf*cm , 89 ft.*lbf }
- for 4WD and Pre-Runner:
- 105 N*m{ 1071 kgf*cm , 77 ft.*lbf }
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 4. CHECK SPEED SENSOR SIGNAL |
w/ ABS:
Check the speed sensor signal (Click here).
w/ VSC:
Check the speed sensor signal (Click here).
