REMOVAL
Removal / installation · Vehicles built from Aug 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 2.
DRAIN BRAKE FLUID |
 |
- NOTICE:
- Wash off brake fluid immediately if it comes in contact with any painted surface.
| 3.
REMOVE BRAKE ACTUATOR ASSEMBLY |
 |
- Use tags or make a note to identify the reconnection locations.
- Release the latch of the actuator connector and disconnect the connector.
Using a union nut wrench, disconnect the 6 brake lines from the actuator.
Remove the 3 nuts and actuator with bracket.
- NOTICE:
- Be careful not to damage the brake tubes.