2014 Hilux · Service Manual BRAKE

REASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. INSTALL BRAKE PEDAL PAD
  1. Install the pad to the pedal.


2. INSTALL STOP LIGHT SWITCH ASSEMBLY

C111301E01
  1. Install the adjuster to the support.

  1. Insert the switch into the adjuster until it slightly touches the pedal.

    NOTICE:
    Do not depress the pedal.

  1. C111302E01
    Turn the switch a quarter turn clockwise.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf } or less

    NOTICE:
    Do not depress the pedal.

  1. Connect the switch connector to the switch.

  1. Check the switch clearance.

    Stop light switch clearance:
    1.5 to 2.5 mm (0.0591 to 0.0984 in.)


3. INSTALL BRAKE PEDAL SUB-ASSEMBLY

  1. C213466E02
    Apply a light coat of lithium soap base glycol grease to 2 new bushes, the brake pedal shaft collar and shaft.

  1. Install the brake pedal shaft collar and 2 bushes to the pedal.

  1. Install the pedal to the support with the shaft and nut.

    Torque:
    26 N*m{ 265 kgf*cm , 19 ft.*lbf }

← ADJUSTMENT (from Aug 2014)INSTALLATION (Jun 2011 – Jul 2012) →