2014 Hilux · Service Manual BRAKE

INSTALLATION

Removal / installation · Vehicles built from Jun 2011


1. INSTALL VACUUM PUMP ASSEMBLY

C111342
  1. Install 2 new O-rings.

  1. Install the pump to the engine with the 2 nuts.

    Torque:
    21 N*m{ 210 kgf*cm , 15 ft.*lbf }

  1. Connect the 2 hoses to the pump with the clip.


2. CHECK VACUUM PUMP ASSEMBLY

C111341E01
  1. Disconnect the vacuum hose from the vacuum pump.

  1. Connect the hose of a vacuum gauge to the pump.

  1. Insert a plug into the other hose of the gauge.

  1. Start the engine and warm it up for more than 2 minutes.

  1. With the engine idling, measure the negative pressure of the pump.

    Standard negative pressure:
    More than 86.7 kPa (650 mmHg, 26 in.Hg)

    HINT:
    The vacuum pump assembly is listed as one of the 200000 km (124000 mile) maintenance parts. Make sure to disassemble and inspect it every 200000 km (124000 miles) and replace parts as necessary.

  1. Remove the gauge from the pump.

  1. Connect the hose to the pump with the clip.


3. INSTALL NO. 1 ENGINE UNDER COVER

4. INSTALL NO. 2 ENGINE UNDER COVER
← REASSEMBLY (from Jun 2011)COMPONENTS (from Jun 2011) →