2014 Hilux · Service Manual BRAKE

REASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. INSTALL VACUUM PUMP BEARING

C111354
  1. Using a press, press in a new bearing to the shaft.


2. INSTALL VACUUM PUMP SHAFT

C111355E01
  1. Using SST and a press, press in the shaft to the housing.

    SST
    09608-04031  

  1. C111349
    Using snap ring pliers, install a new snap ring.

    NOTICE:
    Make sure that the snap ring is firmly installed to the groove.


3. INSTALL VACUUM PUMP GEAR
  1. Install the woodruff key and gear to the pump with the gear lock nut.

  1. C111348
    Mount the gear in a vise.

    NOTICE:
    Place aluminum plates on the vise to prevent damage to the gear.

  1. Tighten the gear lock nut.

    Torque:
    110 N*m{ 1125 kgf*cm , 81 ft.*lbf }


4. INSTALL VACUUM PUMP BLADE

C111356E01
  1. Apply engine oil to the rotor, and install the rotor to the housing.

  1. Install the 5 new blades with the round end facing outward.

    HINT:
    1. Apply engine oil to the blade.
    2. Make sure that the blades are flush with the rotor surface.


5. INSTALL VACUUM PUMP END COVER

C111346
  1. Mount the pump in a vise.

    NOTICE:
    Place aluminum plates on the vise to prevent damage to the pump.

  1. Install 2 new O-rings.

  1. Install the end cover and temporarily install the 3 bolts.

  1. Using a 5 mm pin punch and hammer, tap in the 2 straight pins.

  1. C111345
    Tighten the 3 bolts.

    Torque:
    7.9 N*m{ 80 kgf*cm , 69 in.*lbf }


6. INSTALL CHECK VALVE SUB-ASSEMBLY

C111344
  1. Install a new gasket and the check valve.

    Torque:
    74 N*m{ 749 kgf*cm , 54 ft.*lbf }

  1. C111343
    Install 2 new gaskets and the union with the union bolt.

    Torque:
    14 N*m{ 140 kgf*cm , 10 ft.*lbf }

    HINT:
    Align and insert the union pin into the matching hole of the casing.

← INSPECTION (from Jun 2011)INSTALLATION (from Jun 2011) →