2014 Hilux · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built from Jun 2011

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedures listed below is for the LH side.


1. REMOVE FRONT WHEEL

2. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.


3. REMOVE FRONT FLEXIBLE HOSE

  1. C121982
    Remove the union bolt and gasket.

  1. Disconnect the flexible hose from the disc brake cylinder.


4. REMOVE DISC BRAKE CYLINDER ASSEMBLY LH

  1. C121983
    Remove the 2 bolts and disc brake cylinder assembly.


5. REMOVE FRONT DISC BRAKE PAD
  1. Remove the 2 front disc brake pads from the disc brake cylinder assembly.


6. REMOVE FRONT ANTI-SQUEAL SHIM KIT
  1. Remove the No. 1 and No. 2 anti-squeal shims from each pad.


7. REMOVE FRONT DISC BRAKE PAD SUPPORT PLATE
  1. Remove the 2 pad support plates from the brake cylinder mounting.


8. REMOVE FRONT DISC BRAKE CYLINDER MOUNTING LH

  1. C111362
    Remove the 2 bolts and cylinder mounting.


9. REMOVE FRONT DISC BRAKE CYLINDER SLIDE PIN

  1. C121984
    Remove the 2 front disc brake cylinder slide pins (upper and lower) from the mounting.

  1. C121985E03
    Using a screwdriver, remove the slide bush from the pin (lower).

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    Be careful not to damage the pin.


10. REMOVE FRONT DISC BRAKE BUSH DUST BOOT

  1. C121986
    Remove the 2 boots from the mounting.


11. REMOVE FRONT DISC

  1. C111383E01
    Put matchmarks on the disc and axle hub.

  1. Remove the disc.

← COMPONENTS (from Jun 2011)DISASSEMBLY (from Jun 2011) →