DISASSEMBLY
Removal / installation · Vehicles built from Jun 2011
- HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
| 1.
REMOVE CYLINDER BOOT |
 |
- Using a screwdriver, pry out the cylinder boot.
- HINT:
- Tape the screwdriver tip before use.
- NOTICE:
- Be careful not to damage the brake piston and cylinder.
| 2.
REMOVE FRONT DISC BRAKE PISTON |
 |
- Prepare a wooden plate to hold the pistons.
- Place the wooden plate between the piston and cylinder.
Use compressed air to remove the piston from the cylinder.
- CAUTION:
- Do not place your fingers in front of the piston when using compressed air.
- NOTICE:
- Be careful not to spatter the brake fluid.
| 3.
REMOVE PISTON SEAL |
 |
- Using a screwdriver, pry out the piston seal from the cylinder.
- HINT:
- Tape the screwdriver tip before use.
- NOTICE:
- Be careful not to damage the inner cylinder and cylinder groove.
| 4.
REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP |
|
| 5.
REMOVE FRONT DISC BRAKE BLEEDER PLUG |
 |
Remove the bleeder plug from the cylinder.