2014 Hilux · Service Manual BRAKE

REASSEMBLY

Removal / installation · Vehicles built from Jun 2011

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG
  1. Temporarily install the bleeder plug to the disc brake cylinder.

    HINT:
    The bleeder plug will be tightened to the torque specification in the Bleed Air from Brake Line procedure.


2. INSTALL FRONT DISC BRAKE BLEEDER PLUG CAP

3. INSTALL PISTON SEAL

  1. C191865E01
    Apply a light coat of lithium soap base glycol grease to the entire inner and outer circumference of a new piston seal.

  1. Install the piston seal to the disc brake cylinder.

    NOTICE:
    Make sure the piston seal is securely installed to the groove of the disc brake cylinder.


4. INSTALL FRONT DISC BRAKE PISTON

  1. C239760E02
    Apply a light coat of lithium soap base glycol grease to the inner and outer circumference of a new cylinder boot, and the entire circumference of the top and bottom of the outer edge as shown in the illustration.

  1. Apply a light coat of lithium soap base glycol grease to the entire outer circumference of the front disc brake piston where it contacts the cylinder boot and front disc brake cylinder.

  1. Install the cylinder boot to the front disc brake piston.

  1. Install the front disc brake piston to the front disc brake cylinder.

    NOTICE:
    Do not forcibly install the disc brake piston to the disc brake cylinder.


5. INSTALL CYLINDER BOOT

  1. C122015E01
    Using SST and a hammer, tap in the boot to the disc brake cylinder.
    SST
    09550-60010  

    NOTICE:
    1. Do not damage the cylinder boot.
    2. Install the boot securely to the grooves of the cylinder and piston.

← INSPECTION (from Jun 2011)INSTALLATION (from Jun 2011) →