Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch as the detent spring may become detached from the manual valve lever shaft.
Install the park/neutral position switch to the manual valve shaft.
Temporarily install the bolt.
Install a new lock washer and the nut.
Torque:
7.0 N*m{
71 kgf*cm
, 62 in.*lbf
}
Push the control shaft rearward as much as possible.
Return the control shaft lever 2 notches to the N position.
Align the neutral basic line with the switch groove, and tighten the bolt.
Torque:
13 N*m{
130 kgf*cm
, 9 ft.*lbf
}
Using a screwdriver, bend the tabs of the lock washer.