INSTALLATION
Removal / installation · Vehicles built from Aug 2013
Versions by build date: Jun 2011 – Jul 2013 from Aug 2013
| 1. INSTALL AUTOMATIC TRANSMISSION FLUID TEMPERATURE SENSOR |
Coat a new O-ring with ATF and install it to the temperature sensor.
Using a 19 mm union nut wrench, install the ATF temperature sensor.

- Torque:
- 29 N*m{ 300 kgf*cm , 22 ft.*lbf }
- NOTICE:
- Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).
Attach the ATF temperature sensor connector clamp to the wire harness bracket.
Connect the ATF temperature sensor connector.
| 2. CHECK AUTOMATIC TRANSMISSION FLUID |
Check the automatic transmission fluid (Click here).
