2014 Hilux · Service Manual SUSPENSION & AXLE

DISPOSAL

Removal / installation · Vehicles built from Aug 2012

Versions by build date: Jun 2011 – Jul 2012 from Aug 2012


1. DISPOSE OF FRONT SHOCK ABSORBER ASSEMBLY LH

HINT:
Use the same procedure for the other front shock absorber.

  1. Fully extend the shock absorber piston rod and fix the shock absorber in place at an angle in a vise or similar tool.

  1. C113162E02
    for 4WD, for Pre-Runner (except TMT Made):

    1. Using a drill or similar tool, slowly make a hole approximately 45 mm (1.77 in.) from the top end of the shock absorber and discharge the gas inside of it.

      Text in Illustration 
      *a
      Approximately 45 mm

      NOTICE:
      1. The gas is colorless, odorless and harmless.
      2. Since the discharged gas may cause chips to fly off, cover the drill with a cloth when making a hole.

  1. C273331E01
    for Pre-Runner (TMT Made):

    1. Using a drill or similar tool, slowly make a hole approximately 45 mm (1.77 in.) from the top end of the shock absorber and discharge the gas inside of it.

      Text in Illustration 
      *a
      Approximately 45 mm

      NOTICE:
      1. The gas is colorless, odorless and harmless.
      2. Since the discharged gas may cause chips to fly off, cover the drill with a cloth when making a hole.

← DISPOSAL (Jun 2011 – Jul 2012)COMPONENTS (from Jun 2011) →