2014 Hilux · Service Manual SUSPENSION & AXLE

REMOVAL

Removal / installation · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 from Aug 2012

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. REMOVE FRONT WHEEL

2. DISCONNECT FRONT STABILIZER LINK ASSEMBLY LH

F049984E01
  1. Remove the nut and disconnect the stabilizer link from the steering knuckle.

    HINT:
    If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.


3. DISCONNECT FRONT STABILIZER LINK ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.


4. REMOVE FRONT STABILIZER BRACKET

F050282E02
  1. Remove the 4 bolts and 2 brackets.


5. REMOVE FRONT STABILIZER BAR
  1. Remove the stabilizer bar front from the vehicle body.


6. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING

F049985E01
  1. Remove the nut and bolt.

    HINT:
    While fixing the nut in place, loosen and remove the bolt.

  1. F049986E01
    Remove the 3 nuts and shock absorber with coil spring.


7. REMOVE FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT

  1. F049987E01
    Secure SST in a vise.
    SST
    09727-30021   (09727-00010, 09727-00031)
    09727-00060  

  1. C275706E04
    Attach the arm of SST to the diameter of the coil spring.
    Text in Illustration 
    *a
    Correct
    *b
    Incorrect

    CAUTION:
    1. Make sure that the coil spring is installed so that the distance between the upper and lower hooks of SST is at the maximum.
    2. Make sure that the claws of the hooks are securely attached.

  1. Using SST, compress the coil spring.

    CAUTION:
    1. If the coil spring bends during the compression, immediately stop the compression and reinstall SST.
    2. Do not compress the spring until the coil springs contact each other.
    3. Do not use an impact wrench.

  1. F049988E01
    Hold the shock absorber rod and remove the nut.

    CAUTION:
    Do not remove the front support to front shock absorber nut when the coil spring is not free.


8. REMOVE FRONT SHOCK ABSORBER CUSHION RETAINER
  1. Remove the cushion retainer from the shock absorber.


9. REMOVE FRONT SHOCK ABSORBER CUSHION
  1. Remove the cushion from the shock absorber.


10. REMOVE FRONT SUSPENSION SUPPORT SUB-ASSEMBLY
  1. Remove the suspension support from the coil spring.

  1. Remove the cushion retainer from the shock absorber.


11. REMOVE FRONT COIL SPRING LH
  1. Remove the coil spring from the shock absorber.

← COMPONENTS (from Aug 2012)REMOVAL (from Aug 2012) →