REMOVAL
Removal / installation · Vehicles built from Aug 2012
Versions by build date: Jun 2011 – Jul 2012 from Aug 2012
- HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
| 2.
DISCONNECT FRONT STABILIZER LINK ASSEMBLY LH |
 |
Remove the nut and disconnect the stabilizer link from the steering knuckle.
- HINT:
- If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.
| 3.
DISCONNECT FRONT STABILIZER LINK ASSEMBLY RH |
 |
- HINT:
- Use the same procedure described for the LH side.
| 4.
REMOVE FRONT STABILIZER BRACKET
|
 |
Remove the 4 bolts and 2 brackets.
| 5.
REMOVE FRONT STABILIZER BAR
|
 |
Remove the stabilizer bar front from the vehicle body.
| 6.
REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING |
 |
- for 4WD, for Pre-Runner (except TMT Made):
Remove the nut and bolt.
- HINT:
- While fixing the nut in place, loosen and remove the bolt.
- for Pre-Runner (TMT Made):
Remove the nut and bolt.
- HINT:
- While fixing the nut in place, loosen and remove the bolt.
- Remove the 3 nuts and shock absorber with coil spring.
| 7.
REMOVE FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT |
 |
- Secure SST in a vise.
- SST
- 09727-30021
(09727-00010, 09727-00031)
09727-00060
- Attach the arm of SST to the diameter of the coil spring.
Text in Illustration
*a
|
Correct
|
*b
|
Incorrect
|
- CAUTION:
- Make sure that the coil spring is installed so that the distance between the upper and lower hooks of SST is at the maximum.
- Make sure that the claws of the hooks are securely attached.
Using SST, compress the coil spring.
- CAUTION:
- If the coil spring bends during the compression, immediately stop the compression and reinstall SST.
- Do not compress the spring until the coil springs contact each other.
- Do not use an impact wrench.
- Hold the shock absorber rod and remove the nut.
- CAUTION:
- Do not remove the front support to front shock absorber nut when the coil spring is not free.
| 8.
REMOVE FRONT SHOCK ABSORBER CUSHION RETAINER |
 |
Remove the cushion retainer from the shock absorber.
| 9.
REMOVE FRONT SHOCK ABSORBER CUSHION |
 |
Remove the cushion from the shock absorber.
| 10.
REMOVE FRONT SUSPENSION SUPPORT SUB-ASSEMBLY |
 |
Remove the suspension support from the coil spring.
Remove the cushion retainer from the shock absorber.
| 11.
REMOVE FRONT COIL SPRING LH |
 |
Remove the coil spring from the shock absorber.