2014 Hilux · Service Manual SUSPENSION & AXLE

INSTALLATION

Removal / installation · Vehicles built Apr 2012 – Jul 2012

Versions by build date: Jun 2011 – Oct 2011 Nov 2011 – Mar 2012 Apr 2012 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. INSTALL FRONT UPPER BALL JOINT

  1. C237641E01
    Using SST and a press, press in a new upper ball joint.
    SST
    09612-30012  
    09223-00010  

  1. Using a snap ring expander, install a new snap ring.

    NOTICE:
    Make sure the snap ring is securely installed in the groove.


2. INSTALL UPPER BALL JOINT DUST COVER

  1. C159213E05
    Pack the upper arm ball joint with MP grease No. 2.
    Text in Illustration 
    *1
    MP grease No. 2

    Grease capacity:
    8.0 g (0.282 oz.)

  1. Apply MP grease No. 2 to the locations shown in the illustration.

    NOTICE:
    Do not apply MP grease No. 2 to the tapered or threaded parts of the ball joint.

  1. Install a new dust cover to the upper arm.

  1. Install a new dust cover set ring.


3. INSTALL FRONT UPPER ARM BUSH

  1. F050004E01
    Using SST and a press, press in a new upper arm bush.
    SST
    09710-30021   (09710-03101)


4. TEMPORARILY INSTALL FRONT UPPER SUSPENSION ARM ASSEMBLY LH

C113163E03
  1. Temporarily install the upper arm and 2 retainers with the bolt and nut.

    Text in Illustration 
    *1
    Nut

    HINT:
    Fix the nut in place and temporarily install the bolt.

  1. Install the upper arm to the steering knuckle with the nut.

    Torque:
    110 N*m{ 1122 kgf*cm , 81 ft.*lbf }

  1. Install a new clip.


5. CONNECT FRONT STABILIZER LINK ASSEMBLY LH
  1. Connect the stabilizer link to the steering knuckle with the nut.

    Torque:
    70 N*m{ 714 kgf*cm , 52 ft.*lbf }

    HINT:
    If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.


6. CONNECT FRONT SPEED SENSOR LH (w/ ABS)
  1. Install the 2 bolts and connect the speed sensor wire.

    Torque:
    32 N*m{ 326 kgf*cm , 24 ft.*lbf }


7. INSTALL FRONT WHEEL
  1. Install the front wheel.

    Torque:
    105 N*m{ 1071 kgf*cm , 77 ft.*lbf }


8. STABILIZE SUSPENSION
  1. Lower the vehicle.

  1. Press down on the vehicle several times to stabilize the suspension.


9. TIGHTEN FRONT UPPER SUSPENSION ARM ASSEMBLY LH
  1. Tighten the bolt of the upper arm.

    Torque:
    115 N*m{ 1173 kgf*cm , 85 ft.*lbf }

    NOTICE:
    Do not tighten the nut.


10. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(Click here)
← INSTALLATION (Nov 2011 – Mar 2012)INSTALLATION (Aug 2012 – Jul 2013) →